Vertical
Adjusting Sensitivity and Position
Adjusting Sensitivity
1. Press the appropriate channel push button (channel 1, for example).
OR
Touch Vertical → Channel 1 from the menu bar.
2. Touch inside the Trace On checkbox to display the trace.
3. Turn the
OR
Touch inside the Volts/Div field and enter a value using slider bar.
Click the keypad button to enter a value using the pop‐up keypad,
or use the up/down arrows.
The set voltage is shown on the trace descriptor label and in the
Volts/Div field in the dialog.
Adjusting the Waveform's Position
Turn the V
ERTICAL
button whose waveform you want to move vertically. Or you can touch
inside the Offset field and type in a value on the pop‐up keypad. To set the
vertical offset to zero, touch the Zero Offset button directly below the
Offset field.
WM8Zi‐GSM‐E RevA
V
G
front panel knob for the selected channel.
ERTICAL
AIN
O
adjust front panel knob directly above the channel
FFSET
Getting Started Manual
74