Mouse And Keyboard Operation; Turning On Channels And Traces - LeCroy WaveSurfer MXs-B Getting Started Manual

W S MX -B O
AVE URFER S SCILLOSCOPE

Mouse and Keyboard Operation

In the procedures, we focus on using the front panel for common operations, and
the touch screen for making selections. But, if you have a mouse connected to the
instrument, you can click on objects instead of touching them. Likewise, if you
have a keyboard connected, you can use it to enter data instead of using the
virtual keyboard provided by the instrument.
T C T
URNING ON HANNELS AND RACES
Connect a signal to a channel (we'll assume you connected to channel 1 in this
example and that the channel was not already ON).
Press the channel 1 button on the front panel to turn on channel 1. The button
lights and the descriptor label for that channel are shown.
If the signal is not on the grid, press the AUTO trigger button and adjust
Horizontal and Vertical front panel controls to adjust the settings and display the
signal, or simply press the AUTOSETUP button to quickly bring most repetitive
signals onto the grid.
If you need to change probe attenuation, coupling, or bandwidth limiting, open
the channel setup dialog for channel 1 by touching the descriptor label for
channel 1.
Press this button twice if it is not the active trace. Or, use the Vertical  Channel
1 Setup selection from the menu bar to open the channel 1 setup dialog:
32
WSMXs-B-GSM-E Rev A