Table of Contents
Advertisement
Vertical Settings and Channel Controls
ADJUSTING SENSITIVITY
1. Touch Vertical in the menu bar, then Channel 1 in the drop-down menu.
2. Touch inside the Trace On checkbox to display the trace.
3. Turn the volts per division knob for the selected channel. Or you can touch inside the
Volts/Div field and type in a value using the pop-up keypad. A third way is to use the
up/down arrows.
4. The voltage that you set is displayed in the Volts/Div field and in the trace descriptor
label:
ADJUSTING THE WAVEFORM'S POSITION
Turn the vertical offset adjust knob directly above the channel button whose waveform you want
to move vertically. Or you can touch inside the Offset field and type in a value on the pop-up
keypad. To set the vertical offset to zero, press the vertical offset adjust knob for the channel you
want to adjust:
COUPLING
Your choices of coupling are as follows:
•
DC 50 ohm
•
GROUND
•
DC 1 Mohm
•
AC 1 Mohm
To make a coupling selection, touch inside the Coupling field and choose a coupling mode from
the pop-up menu.
WR6A-GS-E Rev B
G
S
E T T I N G
ISSUED: July 2005
M
T A R T E D
A N U A L
43
Advertisement
Table of Contents
