Using Zoom Dialog Controls; Using Toolbar Shortcuts - LeCroy WaveSurfer MXs-B Getting Started Manual

Using Zoom Dialog Controls

You can also use the Zoom dialog controls to adjust zoom.
Then use the on-screen zoom controls to change the horizontal and vertical
position and scale.
Horizontal scale adjustments always apply to all waveforms.

Using Toolbar Shortcuts

These toolbar shortcuts can be used to perform specific actions for each Zoom
trace.
Opens a Measurement selection pop-up menu. You can then select
a parameter (measurement) for the Zoom trace from this menu
without leaving the Zoom Setup dialog. The parameter
automatically appears below the grid.
Loads the Zoom trace into its corresponding Memory (Reference
Waveform) location (for instance, Z1 is stored into M1; Z2 is stored
into M2, etc.).
Opens a Labeling pop-up menu that allows you to create labels tied
into the waveform.
WSMXs-B-GSM-E Rev A
W S
AVE URFER
Touch the descriptor label to open the Zoom dialog.
MX -B O
S SCILLOSCOPE
58