Table of Contents
Advertisement
G
S
ETTING
TARTED
Configuring the Remote Control Assistant Event Log
Touch Utilities Utilities Setup... from the menu bar.
1.
2.
Touch the Remote tab.
3.
Touch inside the Log Mode data entry field.
4.
Select Off, Errors Only, or Full Dialog from the pop-up menu.
5.
Export the contents of the event log to an ASCII text file by touching the Show
Remote Control Log button. The Event Logs pop-up is shown. Touch inside
the DestFilename data entry field and use the pop-up keyboard to provide a
file name. Now, touch the Export to Text File button.
Aux Output
The following signals can be output through the AUX OUTPUT coaxial connector
on the back of the WaveSurfer MXs-B oscilloscope (this coaxial connector is not
labeled).
Aux Output Off - turns off the auxiliary output signal
Trigger Out - can be used to trigger another oscilloscope
Trigger Enabled - can be used as a gating function to trigger
another instrument when the oscilloscope is ready
Pass/Fail - allows pulse duration setup from 1 ms to 500 ms.
Generates a pulse when pass/fail testing is active and conditions
are met.
Setting Up Auxiliary Output
Touch Utilities Utilities Setup... from the menu bar.
1.
2.
Touch the Aux Output tab.
3.
Touch one of the buttons under Use Auxiliary Output For.
4.
If you selected Pass/Fail, touch inside the Pulse Duration field and enter a
value from 1 ms to 500 ms, using the pop-up numeric keypad.
Note: The CAL output on the front of the WaveSurfer MXs-B oscilloscope is always
set to a 1V / 1 kHz square wave.
109
M
ANUAL
WSMXs-B-GSM-E Rev A
Advertisement
Table of Contents
