Zooming Segments In Sequence Mode - LeCroy WaveSurfer MXs-B Getting Started Manual

Zooming Segments in Sequence Mode

You can zoom individual segments easily using the Q
button. When you zoom, the zoom traces default to Segment 1. Channel
descriptors indicate the total number of segments acquired. Zoom
descriptors indicate [Seg #] and #Segments in the Zoom.
You can scroll through the segments using Z
1. Touch the front panel Quickzoom button.
2. Turn the Z
segments.
3. To vary the degree of zoom, touch the newly created Zx trace label.
The setup dialog for the zoom (Z1 to Z4) opens. It shows the current
horizontal and vertical zoom factors.
4. If you want to increase or decrease your horizontal or vertical zoom
in small increments, touch the Var. checkbox to enable variable
zooming. Now with each touch of the zoom control buttons, the
degree of magnification changes by small increments.
OR
If you want to zoom in or out in large standard increments with
each touch of the zoom control buttons, leave the Var. checkbox
unchecked.
OR
If you want to set exact horizontal or vertical zoom factors, touch
inside the Horizontal Scale/div data entry field and enter a time-
per-div value, using the pop-up numeric keypad. Then touch inside
the Vertical Scale/div field and enter a voltage value.
WSMXs-B-GSM-E Rev A
W
AVE
front panel position knob to scroll through the
OOM
S MX
URFER
OOM
-B O
S SCILLOSCOPE
front panel
UICKZOOM
front panel position knob.
82