Checking The Path Configuration - Hitachi XP P9500 User Manual
Hitachi dynamic link manager software user guide for aix (6.6) (t5208-96012, november 2011)
Hide thumbs
Also See for XP P9500:
- User manual (746 pages) ,
- User manual (188 pages) ,
- User manual (640 pages)
Table of Contents
Advertisement
has failed. After installing HDLM, resolve the problem according to the
KAPL09241-W message if necessary.
When installation is successful, the KAPL09211-I message is output and
the host restarts. After the host has restarted, check to make sure that
the settings have been updated as specified in the installation information
settings file.
Note that, if the upgrade installation or re-installation ends in an error,
HDLM may no longer be installed at all. In this case, proceed to step 12.
If unattended installation ends normally, proceed to step 13.
13
If HDLM was not upgraded or re-installed properly, perform a new
.
installation of HDLM.
¢
¢
After performing a new installation of HDLM, set up HDLM again based on
the HDLM settings backed up in step 7.
14
Unmount the DVD-ROM.
.
# umount /cdrom
15
Delete the created mount directory.
.
# rm -r /cdrom
16
Delete the installation information settings file.
.
# rm -r /directory-containing-the-installation-information-
settings-file
17
Perform the procedure appropriate for the installation type.
.
If you are performing a new installation, perform steps 15 to the end of
the procedure described in
Environment on page 3-28
page
If you are performing an upgrade installation or a re-installation, perform
steps 15 to the end of the procedure described in
in a Boot Disk Environment on page 3-42
Installation or Re-installation of HDLM on page
Checking the Path Configuration
HDLM functions, such as load balancing and failover, are only available for
HDLM management-target devices that have more than one active path. After
When AIX 5L V5.3 is used, and the boot disk is in a multi-path
configuration
Execute the following command to shut down the host, and then
perform the new installation procedure from step 1:
# shutdown -F
When an environment other than the above is used
Execute the following command to restart the host, and then perform
the new installation procedure from step 1:
# shutdown -Fr
3-24.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for AIX(R))
When Installing HDLM in a Boot Disk
of
Performing a New Installation of HDLM on
of
Performing an Upgrade
3-35.
When Installing HDLM
3-67
Advertisement
Table of Contents
