Hitachi XP P9500 User Manual page 215

path(s) were not. Operation name = online
#
-hbaid HBA-port-ID
Use this parameter to place online, at one time, all paths that pass
through a specific HBA port. The command will place online all paths
connected to the HBA port that has the specified HBA-port-ID. To display
the HBA port IDs, execute the following view operation:
# /usr/DynamicLinkManager/bin/dlnkmgr view -hba
For details about how to execute the view operation to display the HBA
port IDs, see To Display HBA Port Information on page 6-58
Parameters on page
Example
The following example shows how to place online all paths connected
to the HBA port whose HBA-port-ID is 00001.
# /usr/DynamicLinkManager/bin/dlnkmgr online -hbaid 00001
KAPL01104-I All the paths which pass the specified HBA port
will be changed to the Online status. Is this OK? [y/n]:y
KAPL01061-I 15 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
#
-cha -pathid AutoPATH_ID
Use this parameter to place online, at one time, all the paths that pass
through a specific CHA port. The command will place online all the paths
that pass through the CHA port to which the path with the specified
AutoPATH_ID is connected.
Specify the current AutoPATH_ID of the target path, which is displayed by
using the view operation. For details about the view operation, see
(Displays Information) on page
(000001 and 1 indicate the same AutoPATH_ID); however, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
AutoPATH_IDs are re-assigned every time the host is restarted. When you
want to add a new LU without restarting the host, AutoPATH_IDs are re-
assigned to each path of the LU when you execute the cfgmgr command.
Always make sure that you use the view operation to find the current
AutoPATH_ID of the target path, before executing the online operation.
Example
The following example shows how to place online the paths connected
to the CHA port 0A. In this example, a path whose AutoPATH_ID is
000002 is connected to the target CHA port.
When the confirmation message is displayed, the user enters y to
continue, or n to cancel the operation.
# /usr/DynamicLinkManager/bin/dlnkmgr online -cha -pathid
000002
Hitachi Dynamic Link Manager User Guide (for AIX(R))
6-32.
6-30. Leading zeros can be omitted
Command Reference
in
view
6-13