Hitachi XP P9500 User Manual page 116
Hitachi dynamic link manager software user guide for aix (6.6) (t5208-96012, november 2011)
Hide thumbs
Also See for XP P9500:
- User manual (746 pages) ,
- User manual (188 pages) ,
- User manual (574 pages)
Table of Contents
Advertisement
Perform steps 4 to 9 of
Environment on page 3-24
page
17
Execute the dlmmigsts utility to restore the HDLM environment settings
.
information and the HDLM execution environment ODM settings that you
saved in step 14.
# /cdrom/HDLM_AIX/hdlmtool/dlmmigsts -r -odm /tmp/any-desired-
directory/odm-environment-settings-file-name -set /tmp/any-
desired-directory/set-environment-settings-file-name
For details about the dlmmigsts utility, see
HDLM Migration on page
18
Execute the following command to reconfigure the device:
.
# cfgmgr
19
Make sure that the HDLM settings information has been properly
.
inherited.
¢
¢
If the HDLM settings information has been properly inherited, skip to step
21.
20
If the HDLM settings information has not been properly inherited, execute
.
the following command:
# /usr/DynamicLinkManager/bin/dlmrmdev
Check the file names for odm-environment-settings-file-name and set-
environment-setting-file-name, and then perform this procedure again
from step 17, specifying the correct file names in the command.
21
Delete the odm environment settings file and the set environment settings
.
file.
# rm -r /tmp/any-desired-directory-that-stores-odm-environment-
settings-file
# rm -r /tmp/any-desired-directory-that-stores-set-environment-
setting-file
22
Perform the procedure described in
.
Disk Environment on page 3-24
on page
3-54
When Installing HDLM in a Local Boot Disk
3-24. Note that you do not have to perform steps 2 to 3.
Make sure that the HDLM environment settings information has been
properly inherited.
Execute the following command, and then compare the current HDLM
environment settings information with the settings information saved
in step 13:
# /usr/DynamicLinkManager/bin/dlnkmgr view -sys
Make sure that the HDLM execution environment ODM settings
information has been properly inherited.
Execute the following command, and then compare the current HDLM
execution environment ODM settings information with the settings
information saved in step 13:
# /usr/DynamicLinkManager/bin/dlmodmset -o
3-24, starting from step 14.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for AIX(R))
in
Performing a New Installation of HDLM on
dlmmigsts Utility for Assisting
7-18.
When Installing HDLM in a Local Boot
in
Performing a New Installation of HDLM
Advertisement
Table of Contents
