Hitachi XP P9500 User Manual page 108
Hitachi dynamic link manager software user guide for aix (6.6) (t5208-96012, november 2011)
Hide thumbs
Also See for XP P9500:
- User manual (746 pages) ,
- User manual (422 pages) ,
- User manual (574 pages)
Table of Contents
Advertisement
Make sure that the fileset item in the output listing contains
DLManager.mpio.rte, and all the displayed statuses are COMMITTED.
If one or more of the displayed statuses are BROKEN, uninstall HDLM, and
then proceed to step 13 to perform a new installation of HDLM.
13
If HDLM was not upgraded or re-installed properly, perform a new
.
installation of HDLM.
¢
¢
After performing a new installation of HDLM, set up HDLM again based on
the HDLM settings backed up in step 2.
14
Execute the following command to restart the host:
.
# shutdown -Fr
15
Execute the following command to make sure that the hdisk driver has
.
been installed in the active kernel and is enabled:
# lsdev -Cc disk
hdisk0 enabled 1S-08-00-8,0
hdisk1 enabled 1S-08-00-9,0
hdisk2 enabled 1S-08-00-10,0 16-bit LVD SCSI disk drive
hdisk3 enabled 1H-08-02
hdisk4 enabled 1H-08-02
...
Make sure that all the displayed HDLM-related devices are enabled.
hdisk0 through hdisk2 are the names of the physical device files for
internal disks on the host.
The files beginning at hdisk3 are the names of the logical device files
corresponding to the storage system's physical volumes.
After executing the lspv command, if there is no hdisk other than the
one that constitutes rootvg, re-execute the procedure starting from step
14.
16
Execute the dlnkmgr command's view operation to check the status of
.
each program:
# /usr/DynamicLinkManager/bin/dlnkmgr view -sys
HDLM Version
Service Pack Version
Load Balance
Support Cluster
3-46
When AIX 5L V5.3 is used, and the boot disk is in a multi-path
configuration
Execute the following command to shut down the host, and then
perform the procedure in
Target Device on page
# shutdown -F
When an environment other than the above is used
Execute the following command to restart the host, and then perform
the procedure in
Perform Operations for HDLM Management-Target
Device on page
3-34:
# shutdown -Fr
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for AIX(R))
Perform Operations for HDLM Management-
3-34:
16-bit LVD SCSI disk drive
16-bit LVD SCSI disk drive
Hitachi Disk Array (Fibre)
Hitachi Disk Array (Fibre)
: x.x.x-xx
:
: on(rr)
:
Advertisement
Table of Contents
