To use the disk capacity for an Active Hot Spare, enable the Active Hot Spare feature if not
currently enabled. For more information, see
chapter.
Including a Disk
A disk must be included in the disk array configuration before it can be used by the disk array. There are
two ways to include a disk:
You can enable Auto Include, which will automatically include a disk when it is inserted into the disk
array enclosure.
You can manually include each new disk.
For convenience, Auto Include is enabled by default on a new disk array. For information on disabling Auto
Include, see
"Changing Disk Array Configuration
After including a disk, you must decide how you want to use it. For more information, see the preceding
section,
"Adding a
Disk."
To manually include a disk, type:
arraycfg -D slot -a <array-id>
slot is the cabinet shelf containing the disk drive (A1 through A6, or B1 through B6)
Using the ARM Command Line Utilities for HP-UX
"Changing Disk Array Configuration
Settings" in this chapter.
Adding a Disk
Settings" in this
45