Summary of Contents for HP Surestore Disk Array 12h - And FC60
Page 1
Single Controller Installation Instructions These instructions apply only when installing an HP SureStore E Disk Array 12H with a single controller. If you are installing a single controller disk array, read this sheet and follow the instructions carefully. Single Controller Slot Selection A single controller should be installed in slot X as shown in the following figure.
Page 2
Suppressing Single-Controller Warning Messages When a single controller disk array is turned on for the first time, the control panel may display a “System Warning” error message, which occurs because only one controller is installed. By default, the disk array assumes there should be two controllers installed, and therefore it will generate single-controller error messages until you suppress them.
Need help?
Do you have a question about the Surestore Disk Array 12h - And FC60 and is the answer not in the manual?
Questions and answers