Checking the Progress of a Rebuild
You can easily check the progress of a Rebuild. This allows you to determine approximately when a
Rebuild will complete.
To check the progress of a Rebuild, type:
arrayrbld -p <array-id>
Canceling a Rebuild
A Rebuild can be canceled only if it was started manually. A Rebuild that was started by Auto Rebuild
cannot be canceled. If a Rebuild is canceled, it must be started over again and any progress made during the
first Rebuild will be lost.
When canceling a Rebuild, the Rebuild may not stop immediately. This occurs if the disk array is busy
servicing higher priority I/O requests from the host. The Rebuild will be canceled when the disk array has
serviced all higher priority commands.
To cancel a manual Rebuild, type:
arrayrbld -c <array-id>
Using the ARM Command Line Utilities for MPE
Rebuilding the Disk Array
139