Viewing The Disk Array General Configuration Settings - HP Surestore Disk Array 12h - And FC60 System Administrator Manual

Using the ARM Command Line Utilities for HP-UX

Viewing the Disk Array General Configuration Settings

Viewing the Disk Array General Configuration Settings
Checking the general configuration settings allows you to view the current settings for all the disk array
operating parameters. The settings include the current status of the array, the array configuration, and the
SCSI configuration settings.
A description of each setting is included in Table 9. The default settings have been selected to optimize disk
array operation on HP-UX.
NOTE! Before changing any setting, you should understand what the setting does, and
what effect changing it will have on disk array operation. Be aware that using an
incorrect setting may make it impossible for the host and the disk array to
communicate properly.
To view the general configuration settings, type:
arraydsp -s <array-id>
A complete list of the settings will be displayed.
Parameter
Overall State of Array
Active Hot Spare
Desired
Auto Include
Auto Rebuild
Rebuild Priority
64
Table 9. General Configuration Settings
Default
Setting
READY Specifies the current state of the array
ENABLED Indicates whether the array should reserve space within
which to perform a rebuild process.
ENABLED Indicates the action to be taken when a drive is physically
inserted into the array.
ENABLED Indicates the action to be taken when a drive becomes
unusable.
HIGH Indicates the priority the rebuild process is given with
respect to host I/O.
Description