Mpe/Ix Sysgen Configuration - HP Surestore Disk Array 12h - And FC60 System Administrator Manual
System administrator's guide for hp-ux, mpe, and windows nt
Hide thumbs
Also See for Surestore Disk Array 12h - And FC60:
- Service manual (746 pages) ,
- Advanced user's manual (466 pages) ,
- User manual (310 pages)
Table of Contents
Advertisement
Managing the HP SureStore E Disk Array 12H on MPE
Configuring AutoRAID SCSI LUNs for MPE/iX
MPE/iX SYSGEN Configuration
The following example illustrates how to configure an MPE/iX logical device (LDEV) to a SCSI LUN. It
assumes the configuration of an LDEV to a physical I/O path of 10/16/4.1.0.
NOTE! To obtain the path, use the offline utility ODE and run mapper.
To configure any device on an MPE/iX system, use the SYSGEN configuration from the MPE/iX system
prompt as follows:
:SYSGEN
Within the IO area of SYSGEN, configure the upper level hardware first. For example, a 969KS/100 has
two levels of bus converters, which appear in the path prior to specifying the HP-PB slot number.
The following is a SYSGEN list path(lp) from the io prompt:
io> lp 10
PATH:
10
ID:
A2372-6003
PMGR:
BUS_CONV_MGR
LMGR:
io> lp 10/16
PATH:
10/16
ID:
A2372-60003
PMGR:
BUS_CONV_MGR
LMGR:
122
LDEV:
TYPE: BC
PMGRPRI:
2
MAXIOS:
0
LDEV:
TYPE: BC
PMGRPRI:
2
MAXIOS:
0
Advertisement
Table of Contents
