Recover - HP Surestore Disk Array 12h - And FC60 System Administrator Manual
System administrator's guide for hp-ux, mpe, and windows nt
Hide thumbs
Also See for Surestore Disk Array 12h - And FC60:
- Service manual (746 pages) ,
- Advanced user's manual (466 pages) ,
- User manual (310 pages)
Table of Contents
Advertisement
Using the ARDIAG Offline Diagnostic on MPE
Operational Command Descriptions
RECOVER
The RECOVER command allows the user to restore controller map information in the specified SureStore
E (AutoRAID) Disk Array.
Synopsis
RECOVER
Output
ARDIAG>testdisk 1
Array state is No Address Table
The following warnings are currently in effect:
Disk Warning
Capacity Warning
ARDIAG>testlevel 0
TESTLEVEL = 0
ARDIAG> recover
The logs should be cleared before executing this command.
Do you want to abort to clear logs ([y]/n)? no
There is only one volume set in the array.
0)
"
125B0
Disks: A1
Proceed with recover operation ([y]/n)? yes
Recovery Progress = 1 Percent
Recovery Progress = 2 Percent
Recovery Progress = 3 Percent
.
.
.
184
D")
A2
A3
Advertisement
Table of Contents
Need help?
Do you have a question about the Surestore Disk Array 12h - And FC60 and is the answer not in the manual?