Checking The Progress Of A Rebuild; Canceling A Rebuild - HP Surestore Disk Array 12h - And FC60 System Administrator Manual
System administrator's guide for hp-ux, mpe, and windows nt
Hide thumbs
Also See for Surestore Disk Array 12h - And FC60:
- Service manual (746 pages) ,
- Advanced user's manual (466 pages) ,
- User manual (310 pages)
Table of Contents
Advertisement
Using the ARM Command Line Utilities for Windows NT
Rebuilding the Disk Array
Checking the Progress of a Rebuild
You can easily check the progress of a rebuild. This allows you to determine approximately when a rebuild
will complete.
To check the progress of a rebuild, type:
arrayrbld -p <array-id>
Canceling a Rebuild
A rebuild can be canceled only if it was started manually. A rebuild that was started by Auto Rebuild cannot
be canceled. If a rebuild is canceled, it must be started over again and any progress made during the first
rebuild will be lost.
When canceling a rebuild, the rebuild may not stop immediately. This occurs if the disk array is busy
servicing higher priority I/O requests from the host. The rebuild will be canceled when the disk array has
serviced all higher priority commands.
To cancel a rebuild, type:
arrayrbld -c <array-id>
252
Advertisement
Table of Contents
