HP Surestore Disk Array 12h - And FC60 System Administrator Manual page 206

Using the ARDIAG Offline Diagnostic on MPE
ARDIAG interface to ODE
ARDIAG Utility
-----------------------------------------------------------------------
UTILINFO - Shows commands that do the most common ARDIAG tasks.
HELP - This menu, or use HELP <help item> for more detailed help
DISPMAP - Display the disk arrays found
DISPMECH - Display the selected disk array and internal disks
DISPFILES - Display the firmware images found
DOWNLOAD - Download the image file to the desired disk array
TESTDISK - Select the array to be tested.
TESTLEVEL - Select the FRU within the disk array to be tested.
RANGE - Select range of blocks to be tested by ROMT and WRTMT
SHOWENV - Display the current settings for TESTDISK and RANGE.
READLOG - Read the internal logs of the desired disk array
CLRLOG - Clear the internal logs of the desired disk array
REQSENSE - View SCSI Sense data of the desired disk array
INQUIRY - View SCSI Inquiry data of the desired disk array
DESCRIBE - View Configuration data of the desired disk array.
REVISION - View revision information of the desired disk array.
WRTMT - Perform a DESTRUCTIVE write/read test on the desired disk
ROMT - Perform a read only test on the desired disk.
CREATELUN - Adds a LUN to the selected disk array.
DELETELUN - Removes a LUN from the selected disk array.
SHUTDOWN - Puts the selected disk array into the shutdown state.
SETOPTIONS - View and modify SCSI mode parameters on the selected
RECOVER - Reconstruct data mapping and array configuration.
Continue ([y]/n)? n
206
Help Menu
controller or internal disk.
controller or internal disk.
controller or internal disk.
controller or internal disk.
controller or internal disk.
array controller.