Formatting The Disk Array - HP Surestore Disk Array 12h - And FC60 System Administrator Manual

Using the ARM Command Line Utilities for MPE
Performing Disk Array Maintenance Tasks
Table 18. arraylog Options for Displaying Log Contents
Option
-u Display the contents of the disk array controller usage log.
-e Display the contents of the disk array controller event log.
-d slot Display the contents of the log for the disk installed in the cabinet slot
identified by slot. Slot numbers must be of the form "An" or "Bn", where
A or B correspond to a cabinet column, and n corresponds to a shelf
position (1-6).
-C {-c | -d slot} Clear the specified logs. If -c is specified, clear the disk array controller
usage and event logs. Both logs will be cleared when using this option.
It is not possible to clear just one of the logs. If -d is specified, clear the
log for the disk installed in the cabinet slot identified by slot.
To display the contents of a hardware log, type:
arraylog [-u] [-e] [ -d slot ] <array-id>
To clear the hardware logs, type:
arraylog [-C{-c|-d slot}] <array-id>

Formatting the Disk Array

Should it become necessary to do so, you can format the entire disk array, or a single LUN. Formatting
destroys all data on the array or LUN involved. Formatting an array first requires that all LUNs be deleted.
To format the entire disk array, type:
arrayfmt -F [-h] <array-id>
To format a LUN, type:
arrayfmt -L LUN <array-id>
146
Description