Including A Disk Manually - HP Surestore Disk Array 12h - And FC60 System Administrator Manual
System administrator's guide for hp-ux, mpe, and windows nt
Hide thumbs
Also See for Surestore Disk Array 12h - And FC60:
- Service manual (746 pages) ,
- Advanced user's manual (466 pages) ,
- User manual (310 pages)
Table of Contents
Advertisement
Using the ARM Command Line Utilities for Windows NT
Adding a Disk
Including a Disk Manually
A disk must be included in the disk array configuration before it can be used by the disk array. There are
two ways to include a disk:
You can enable Auto Include, which will automatically include a disk when it is inserted into the disk
array enclosure.
You can manually include each new disk.
For convenience, Auto Include is enabled by default on a new disk array. For information on disabling Auto
Include, see
"Changing Disk Array Configuration
After including a disk, you must decide how you want to use it. For more information, see the preceding
section,
"Adding a
Disk."
To manually include a disk, type:
arraycfg -D slot -a <array-id>
slot is the cabinet shelf containing the disk drive (A1 through A6, or B1 through B6)
250
Settings" in this chapter.
Advertisement
Table of Contents
Need help?
Do you have a question about the Surestore Disk Array 12h - And FC60 and is the answer not in the manual?