Restore to Default Settings
If you have customized your preferred and alternate paths, but are not satisfied
with the results, you can reset your data path management settings to the default
settings at the volume group level.
To reset volume group paths to default settings:
1. From the Storage tab, select Volume Groups, and use the tree view (second
2. Select the LUN to reset.
3. Select Actions > Reset LUN Paths to Factory Settings. This will bring up
4. Read the warning, then accept it by checking the box next to the warning and
Recover from a Disaster
Performing disaster recovery for the NAS 8000 removes HP NAS Data Path
Manager from the system. When disaster recovery is required, perform the
following tasks.
1. Recover the NAS 8000 system using the instructions under Disaster Recovery
2. Install NAS Data Path Manager, as discussed in the
3. Re-configure any customized path settings as described at
hp StorageWorks NAS Data Path Manager Installation and User's Guide
icon to the right of Actions).
the Reset selected LUN Paths to factory settings dialog box.
selecting OK.
in the hp StorageWorks NAS 8000 User's Guide.
section on page 15 of this guide.
Paths
on page 28.
NAS Data Path Manager
Install the Software
Manage the Data
33