Modifying The Radius Server; Modifying The Radius Server Order - Brocade Communications Systems 8 Administrator's Manual

17
RADIUS management
4. Enter the RADIUS server name, as a valid IP address (in either IPv4 or IPv6 format) or Dynamic
5. Enter the port number.
6. Enter the secret string.
7.
8. Select either CHAP or PAP as the authentication protocol.
9. Click OK to return to the AAA Service tab.
10. Click Apply.

Modifying the RADIUS server

Use the following procedure to change the parameters of a RADIUS server that is already
configured.
1. Open the Switch Administration window as described in
2. Select the AAA Service tab.
3. Select a RADIUS server from the RADIUS Configuration list.
4. Click Modify.
5. Enter new values for the port number, timeout time (in minutes), and secret string.
6. Select either CHAP or PAP as the authentication protocol.
7.
8. Click Apply.

Modifying the RADIUS server order

The RADIUS servers are contacted in the order they are listed, starting from the top of the list and
moving to the bottom.
Use the following procedure to modify the RADIUS server order.
1. Open the Switch Administration window as described in
2. Select the AAA Service tab.
3. Select a RADIUS server from the RADIUS Configuration list.
226
DRAFT: BROCADE CONFIDENTIAL
The RADIUS Configuration dialog box displays. You can configure up to five RADIUS servers. If
five RADIUS servers are already configured, the Add button is disabled.
Name Server (DNS) string.
Each RADIUS server must have a unique IP address or DNS name for the RADIUS server.
Enter the timeout time in minutes.
The default value is CHAP, and if you do not change it, CHAP becomes the authentication
protocol.
window" on page 35.
The RADIUS/ADLDAP Configuration dialog box displays.
The default value is CHAP, and if you do not change it, CHAP becomes the authentication
protocol.
Click OK to return to the AAA Service tab.
window" on page 35.
"Opening the Switch Administration
"Opening the Switch Administration
Web Tools Administrator's Guide
53-1001772-01