Xilinx MIcroBlaze Development Spartan-3E 1600E Kit User Manual page 98

Chapter 12: SPI Serial Flash
The PROM Formatter then echoes the settings, as shown in
The PROM Formatter then prompts for the name(s) of the FPGA configuration bitstream
file. As shown in
(*.bit). Choose No after selecting the last FPGA file. Finally, click OK to continue.
When PROM formatting is complete, the iMPACT software presents the present settings
by showing the PROM, the select FPGA bitstream(s), and the amount of PROM space
consumed by the bitstream.
bitstream stored in an XCF04S Platform Flash PROM.
96
www.xilinx.com
Figure 12-10: Click Finish after Entering PROM Formatter Settings
Figure 12-11, click OK to start selecting files. Select an FPGA bitstream file
Figure 12-11: Enter FPGA Configuration Bitstream File(s)
Figure 12-12
MicroBlaze Development Kit Spartan-3E 1600 Edition User Guide
Figure
UG257_12_11_060806
shows an example for a single XC1600E FPGA
UG257 (v1.1) December 5, 2007
R
12-10. Click Finish.
UG257_12_10_060806