Chapter 4: FPGA Configuration Options
Programming Platform Flash PROM via USB
The on-board USB-JTAG circuitry also programs the two Xilinx XCF04S serial Platform
Flash PROM. The steps provided in this section describe how to set up the PROM file and
how to download it to the board to ultimately program the FPGA.
Generating the FPGA Configuration Bitstream File
Before generating the PROM file, create the FPGA bitstream file. The FPGA provides an
output clock, CCLK, when loading itself from an external PROM. The FPGA's internal
CCLK oscillator always starts at its slowest setting, approximately 1.5 MHz. Most external
PROMs support a higher frequency. Increase the CCLK frequency as appropriate to reduce
the FPGA's configuration time. The Xilinx XCF04S Platform Flash supports a 25 MHz
CCLK frequency.
Right-click Generator Programming File in the Processes pane, as shown in
Figure
30
www.xilinx.com
Figure 4-9: iMPACT Programming Succeeded, the FPGA's DONE Pin is High
4-10. Left-click Properties.
MicroBlaze Development Kit Spartan-3E 1600 Edition User Guide
UG257_09_061206
UG257 (v1.1) December 5, 2007
R