Initial Setup Using The Storage Setup Manager For Windows; Download The Hpe Storage Toolkit For Windows - HP HPE Alletra 2140 Hardware Manual

name resolution must be configured on the Data Orchestrator and be allowed to resolve global Internet names and domains.
The Data Orchestrator will periodically transmit health and statistical telemetry over HTTPS/TLS.
If you are unable to resolve the issue, contact support.

Initial Setup Using the Storage Setup Manager for Windows

After your array has been installed in the rack and connected to your network, you must complete the initial setup of the array
by configuring some basic settings to get the array running on the network and connected to HPE GreenLake.
This chapter describes how to complete the initial setup from a Windows host. If you do not have a Windows host from which
to complete the initial setup, you must use the CLI. For more information, see Initial Setup Using the Array CLI on page 43.
After the initial setup is complete, refer to the GUI Administration Guide or the CLI Administration Guide for group and volume
configuration, and additional optional configuration tasks.

Download the HPE Storage Toolkit for Windows

Download the latest version of the HPE Storage Toolkit for Windows to install on your Windows host or Windows VM.
Important: Make sure that the version of the toolkit is compatible with the version of the operating system on your
array. For compatibility information, see the Validated Configuration Matrix tool, which is available on HPE InfoSight
(https://infosight.hpe.com/resources/nimble/validated-configuration-matrix).
Before you begin
What you need on a Windows server:
Internet connection to HPE InfoSight
.NET Framework 4.5.2
What you need on a Windows client:
Internet connection to HPE InfoSight
Windows OS 7 or later
.NET Framework 4.5.2
Procedure
1. In your Internet browser, go to http://www.hpe.com/support/storage-welcomecenter
https://infosight.hpe.com/welcomecenter.
2. On the Welcome Center home screen, click the array family.
3. Select the array model and click Continue.
4. In the navigation panel, click Software Configuration > Prepare Client.
5. Follow the instructions to download the toolkit.
6. Save the installation package to your Windows host.
The installation package has a name similar to Setup-HPEStorage-x64.x.x.x.x.exe, where x64 is the
supported microprocessor and x.x.x.x is the version number.
7. Download the latest Toolkit Release Notes.
Review the list of Windows Server hotfixes.
Note: If you are installing the setup manager alone, then no hotfixes are needed. However, .NET framework
requirements still apply. Hotfix requirements are mandatory for any Windows host on which the HPE Storage
Connection Manager for Windows is used to connect to array volumes.
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
Install the HPE Storage Array 38