Removing A Hot-Swap Hard Disk Drive - Lenovo ThinkServer sd350 Installation And Service Manual

Figure 29. System fan installation
Step 2. Install the replacement fan in the bracket:
a. Insert the fan into the bracket.
b. Make sure that each of the locking tabs on the fan is fully seated in its slot in the fan bracket.
Step 3. Reinstall the fan cage cover (see "Installing the fan cage cover" on page 83).
1. Push the server into the rack until it clicks into place.
2. Reconnect the power cords and any cables that you removed.
3. Turn on the peripheral devices and the server.

Removing a hot-swap hard disk drive

Use this information to remove a hot-swap hard disk drive.
Attention:
• To avoid damage to the hard disk drive connectors, make sure that the server cover is in place and fully
closed whenever you install or remove a hard disk drive.
• To make sure that there is adequate system cooling, do not operate the server for more than 2 minutes
without either a hard disk drive or a filler panel installed in each bay.
• Before you make changes to disk drives, disk drive controllers (including controllers that are integrated
on the system board), disk drive backplanes, or disk drive cables, back up all important data that is
stored on hard disks.
• Before you remove any component of a RAID array, back up all RAID configuration information.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 75.
To remove a hot-swap hard disk drive, complete the following steps.
90
Lenovo ThinkServer sd350 Server Type 5493, Lenovo ThinkServer n400 Enclosure Type 5495Installation and Service Guide