Removing A 2.5-Inch Hot-Swap Hard Disk Drive - Lenovo THINKSERVER 3822 Hardware Maintenance Manual

10. Install the bezel (see "Installing the bezel" on page 154).
11. Install and lock the left-side cover (see "Installing the left-side cover" on page
12. Reconnect the external cables and power cords; then, turn on the attached

Removing a 2.5-inch hot-swap hard disk drive

To remove a hot-swap hard disk drive, do the following:
1. Read the safety information that begins on page 5.
2. Open the bezel (see "Opening the bezel" on page 150).
6. Install the fan-cage assembly (see "Installing the fan-cage assembly" on page
172).
7. Install the air baffle (see "Installing the air baffle" on page 170).
8. Return the power-supply cage to its closed position (see "Closing the
power-supply cage" on page 160).
9. Install the hot-swap power supply or power supplies (see "Installing a hot-swap
power supply" on page 175).
158).
devices and turn on the server.
1
Filler panel
2
Hard disk drive assembly
3
Release latch
4
Drive handle
Attention: Static electricity that is released to internal server components
when the server is powered on might cause the server to halt, which might
result in the loss of data. To avoid this potential problem, always use an
electrostatic-discharge wrist strap or other grounding system when you work
inside the server with the power on.
Chapter 7. Installing optional devices and replacing customer replaceable units
195