Even When Slip Paper Is Set, Paper Is Fed And An Error Occurs; Slip Led Does Not Turn Off Even Though Slip Paper Is Removed; Micr Cannot Be Read - Epson TM-H6000V Technical Reference Manual

Even when slip paper is set, paper is fed and an error occurs

Cause
The paper being used does not match
the printer driver settings.

Slip LED does not turn off even though slip paper is removed

Cause
There are small pieces of paper in the
paper path.

MICR cannot be read

Cause
The paper insertion position is not cor-
rect.
The paper insertion direction is not cor-
rect.
The paper is bent.
There is a device that emits magnetic
fields, such as a display, nearby.
The MICR head is dirty.
Solution and reference
Check the printer driver settings.
Solution and reference
Remove any small pieces of paper that are in the paper path (B in the illustra-
tion).
There is a sensor that detects paper in the paper path (circled in the illustra-
tion). The sensor enclosed by the dotted line is not available on some models.
Confirm that there are no small pieces of paper remaining in the paper path,
and then close all of the covers. If the Slip LED still does not stop flashing,
download the Slip Paper Sensor Adjustment Tool (Windows only), and adjust
the sensitivity of the Slip paper sensor (A in the illustration).
Solution and reference
Push the paper fully against the right side.
Check the paper direction.
Use paper that is not curled, folded, curved, or wrinkled along the edges.
Do not use this product near devices that emit magnetic fields.
Perform MICR cleaning.
See "Cleaning the MICR Head" on page
Chapter 6 Troubleshooting
96.
6
106