Controller Specifications; Software Specifications - Epson EPL-N2000 Service Manual

EPL-N2000 Service Manual

1.2.10 Controller Specifications

CPU:
RAM:
ROM:
EEPROM:
Host interface:
Optional slots:
*1: Expanded with up to 2 SIMMs
*2: Type-B I/F Board (C82331*) (standard) is instsalled in Type-B slot.
*3: Remove Type-B I/F Board (C82331*) (Standard) before inserting Type-B I/F card.
Make sure power is off when installing and removing options.

1 .2.11 Software Specifications

Built-in emulation modes:
PCL5e *
GL/2 *
EPSON GL/2 *
FX
ESC/P 2
I239X
*1: Included in HP LaserJet 4 emulation.
*2: EPSON GL/2 mode, which emulates the GL/2 mode in the HP LaserJet 4 emulation, has 2
modes; LJ4-GL2 mode and GL-like mode.
LJ4-GL2 mode: Used to print with software that supports the HP 7600 series electrostatic
plotter. It emulates GL/2 mode in the HP LaserJet 4 emulation. In EPSON
GL/2 mode, however, the operator can reach some parameters with
SelecType, without sending commands.
GL-like mode: Used to print with software that supports the HP7475A series pen plotter.
GL-like mode features all the commands for LJ4-GL/2 mode, except some
instructions such as plotter unit and picture frame, that are the same as in
EPSON GL/2 mode. However, since GL-like mode doesn't support some
commands used in the HP GL mode, print cannot be assured with
application software that specifies those commands.
See Table 1-11 for differences between LJ4-GL/2 mode and the GL-like mode.
Rev. A
RISC type CPU:
Clock speed:
Standard:
1
Max.* :
4MB
16Kbits
Standard:
Optional:
RAM SIMMs:
ROM SIMM:
PCMCIA:
NLSP socket:
Type B:
CAUTION
1
1
2
Product Description
MB86935-50
47.6 MHz
4MB
68MB
B idirectional parallel B type / C type
2
Ethernet*
3
Type B *
LocalTalk/Serial Module
2 slots
1 slot
1 slot
1 slot
1 slot
1-13