Removing The Pick-Up Roller; Installing The Pick-Up Roller - Canon NP6045 Service Manual

CHAPTER 5 PICK-UP/FEEDING SYSTEM

2. Removing the Pick-Up Roller

1) Open the multifeeder paper guide.
2) Remove the stop rings
shutters and the two rollers
Caution:
If the multifeeder was used at time of installation or if it was used after a long time,
pick-up operation may fail.
If such is the case, remove the protection sheet from the sponge roller, and dry wipe
the surface of the sponge roller.

3. Installing the Pick-Up Roller

Install the pick-up roller by reversing the steps used to remove it with the following in
mind.
• The front and rear pick-up rollers are not interchangeable.
• The front pick-up roller is silver.
When installing the pick-up roller
marking on the collar (silver) is toward the front.
5-54
COPYRIGHT © 1997 CANON INC.
from both left and right 1 (two each); then, remove the
(two each).
Figure 5-802
to the pick-up assembly, be sure that the round
Direction of
rotation
Collar (silver)
Marking (roller)
Marking (collar)
Figure 5-803
Front (copier)
CANON NP6045 REV. 1 MAR. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)