Canon NP6045 Service Manual page 402

CHAPTER 8 INSTALLATION
No.
12 When toner has been supplied,
place the Test Sheet on the
copyboard, and make copies to
check the image.
Toner may fall from the drum
separation claw to cause soiled
images on the first ten or so copies;
such a condition will disappear when
more copies have been made.
Check to make sure that paper is
picked up from all sources of paper.
13 Make two-sided and overlay copies.
14 Set the standard mode in user mode
and service mode (*5*) to suit the
user's needs.
Register the paper size for the paper
deck in service mode (*5*).
DK-SZ-R (paper deck)
Press the Reset key twice to end
service mode.
15 Remove the door switch retaining
tool, and install the cover, fixing knob,
and releasing lever to the fixing
feeding unit; then, close the front door.
16 Clean up the area around the machine.
17 Move the copier to the site of
installation, and fix it in position using
the two adjusters.
18 As necessary, turn ON the drum
heater switch (by pushing it on the
right side) to suit the environment.
8-26
COPYRIGHT © 1997 CANON INC.
Work Checks/remarks
• Check to make sure that there is no abnormal
sound.
• Make copies at each default ratio, and check
the copy image of each.
• Check to make sure that as many copies as
set are made normally.
• If the density is different between left and
right, adjust the height of the rear of the
primary charging assembly to correct.
• Check to make sure that copying operation is
normal.
• Check to make sure that there is no abnormal
sound.
• Check to make sure that paper movement at
the holding tray assembly is normal.
CANON NP6045 REV. 1 MAR. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)