Control Panel; Removing The Control Panel From The Copier - Canon NP6045 Service Manual

CHAPTER 7 EXTERNALS/AUXILIARY MECHANISMS
2) After inserting the process unit into the copier, match the slit of the drum shaft and
the slit of the drum using the drum rotating tool
and insert the mounting screw
B. Control Panel

1. Removing the Control Panel from the Copier

1) Remove the mounting screw from the upper left cover, and remove the two stepped
screws (M3x6) from the standard white cover.
2) Open the RDF, and remove the three mounting screws
fixings .
7-20
COPYRIGHT © 1997 CANON INC.
. Then, insert the drum fixing
into the center hole in the drum rotating tool.
Figure 7-415
Figure 7-416
CANON NP6045 REV. 1 MAR. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
and the three RDF catch
,