Removing The Waste Toner Bottle; Removing The Fixing/Waste Toner Drive Assembly - Canon NP6045 Service Manual

2. Removing the Waste Toner Bottle

1) Remove the mounting screw, remove the lower right cover, and slide out the waste
toner bottle to the side of the multifeeder.

3. Removing the Fixing/Waste Toner Drive Assembly

1) Open the front door, and slide out the process unit, fixing/feeding unit, and holding
tray assembly about 10 cm from the copier.
2) Remove the rear cover.
3) Remove the high-voltage transformer PCB.
4) Remove the cleaner fan and the feeding fan.
5) Remove the waste toner bottle.
6) Remove the spring
.
7) Remove the three mounting screws
drawer connector
COPYRIGHT © 1997 CANON INC.
, and loosen the tension pulley
Figure 7-441
.
Figure 7-442
CANON NP6045 REV. 1 MAR. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 7 EXTERNALS/AUXILIARY MECHANISMS
; then, detach the timing belt
, and disconnect the holding tray assembly
7-33