Cassette Pick-Up Drive Assembly; Construction; Removing The Cassette Pick-Up Drive Assembly - Canon NP6045 Service Manual

M. Cassette Pick-Up Drive Assembly

1. Construction

2. Removing the Cassette Pick-Up Drive Assembly

1) Open the front door, and slide out the holding tray assembly about 10 cm from the
copier.
2) Remove the rear cover.
3) Remove the waste toner bottle.
4) Remove the waste toner bottle support plate.
5) Remove the rear right grip assembly.
6) Remove the DC controller PCB, and detach the timing belt.
7) Remove the two mounting screws
assembly of the cassettes 3 and 4); then, disconnect the connector
COPYRIGHT © 1997 CANON INC.
Figure 7-461
Figure 7-462
CANON NP6045 REV. 1 MAR. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 7 EXTERNALS/AUXILIARY MECHANISMS
(two each of the paper width detection
(one each).
7-43