Table of Contents
Advertisement
2) Remove the saddle inside cover (lower). (page 4-9)Reference[Remov-
ing the Saddle Inside Cover (Lower)]
4.4.1.2 Removing the Engaging Roller
1) Remove the resin ring [1] and ball bearing [2].
[2]
[1]
2) Remove the resin ring [1] of the back side of the saddle area and gear re-
tainer [2].
3) Remove the belt [1] from the gear [2].
4) Move the engaging roller shaft [1] as the direction of the arrow (inside
side), remove the bushing of the front side only.
F-4-104
[2]
[1]
F-4-105
[1]
[2]
F-4-106
0020-8575
5) Remove the engaging roller (front) [1] to the front direction.
- 1 screw [2]
6) After removing the separation roller (front) from the engaging roller
(rear), remove the engaging roller (front) as the procedure.
4.4.2 Stack Delivery Roller
4.4.2.1 Preparation for Removing Stack Delivery Upper
Roller
1) Remove the stack wall (upper). (page 4-8)Reference[Removing the
Stack Wall (Upper)]
2) Remove the stack wall (lower). (page 4-8)Reference[Removing the
Stack Wall (Lower)]
3) Remove the process tray assembly. (page 4-26)Reference[Removing
the Process Tray Assembly]
4.4.2.2 Removing Stack Delivery Upper Roller
1) Remove the 2 tension springs [1].
2) Stand the process tray assembly [1].
[1]
F-4-107
[2]
[1]
F-4-108
[1]
F-4-109
Chapter 4
0020-8578
0020-8579
[1]
4-25
Advertisement
Table of Contents
