Adjusting The Ae Slope - Canon NP6045 Service Manual

6) Place a newspaper on the copyboard, and close the copyboard cover.
7) Press the user mode key once.
The scanning lamp will turn ON, and auto adjustment will be executed.
AE_ADJ : 0
Changes to '0'.
8) Press the Reset key twice to end service mode.

7. Adjusting the AE Slope

After executing AE auto adjustment, make a copy of a dark original (e.g.,
newspaper). If the copy is foggy or too light, perform the following:
1) Open the front door, and insert the door switch actuator into the door switch
assembly.
2) Press the service mode switch over the cover with a clip.
3) Select 'AE_SLOP' in service mode (
4) Place a dark original (e.g., newspaper).
5) Change the setting using the keypad, and press the
If the setting was decreased in adjustment mode, the copy of a newspaper will be
lighter.
If the setting was increased in adjustment mode, the copy of a newspaper will be
darker.
Note:
You can make copies by pressing the Copy Start key.
6) Press the Reset key twice to end service mode.
COPYRIGHT © 1997 CANON INC.
( :START)
CANON NP6045 REV. 1 MAR. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 10 TROUBLESHOOTING
).
3
user mode key.
10-9