J. Charging Wire
1. Outline
The primary, pre-transfer, transfer/separation charging wires are located around the
photosensitive drum. (The wire diameter is 0.06 mm.)
2. Removing the Primary Charging Assembly Wire Cleaner
1) Hold the wire cleaner, and disengage it with a flat-blade screwdriver.
3. Installing the Charging Wire
The charging wire (except the grid wire) is installed in the same way for all charging
assemblies. (The following cites the primary charging assembly.)
1) Remove the shielding plate (left, right) of the charging assembly.
Be sure to remove the left and right shielding plates individually to prevent
deformation of the primary charging assembly. (At the same time, take care not to
loosen the mounting screw
2) Remove the wire cleaner.
Caution:
For other assemblies, remove the lid (2 pcs.).
COPYRIGHT © 1997 CANON INC.
Figure 4-323
on the left/right shielding plate.)
Figure 4-324
CANON NP6045 REV. 1 MAR. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 IMAGE FORMATION SYSTEM
4-49