Canon NP6045 Service Manual page 569

Item
LIFT Indicates '1' if the lifter position sensor does not turn ON
within 8 sec after the lifter up command is issued for the
paper deck/cassette lifter.
Order of flags
Deck, cassette 3, cassette 4
• LMP1 and LMP2 indicate the ON control voltage even when the scanning lamp is
OFF.
Note:
If '0' is indicated under 'WIRE', be sure to execute 'wire cleaning' in user mode ( ).
If the wire cleaner motor and the wire cleaner unit are normal, executing wire
cleaning will activate the cleaner unit, causing it to stop at home position and
clearing the indication to '0'.
(Unless you execute wire cleaning, wire cleaning will remain prohibited and will not
be reset by turning OFF/ON the power.)
COPYRIGHT © 1997 CANON INC.
Description
CANON NP6045 REV. 1 MAR. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 10 TROUBLESHOOTING
Remarks
Resetting is by
turning OFF and
ON the power
switch.
10-143