Configuring The Merlin Ii R3 System; Programming Speed Dial Access Buttons - AT&T MERLIN MAIL Implementation Manual

Configuring the MERLIN II R3 System

PROGRAMMING
SPEED DIAL ACCESS
BUTTONS
Perform the following MERLIN II R3 system
administration from the MERLIN II R3 System Display
Console.
For more efficient access to the MERLIN MAIL system
features, program a button for Speed Dial Access on all
subscribers' phones so that they do not have to dial the
pound sign (#) twice when using Voice Mail. You can
program the phones individually or use Centralized
Programming as shown below.
At the MERLIN II R3 System Display Console, enter
1
administration mode by sliding the T/P switch to P.
Press [
2
Conference
The Administration Menu appears.
From the Administration Menu, press [
3
[ ], [ ].
More Cntr-Prg
Press the Auto Intercom button of the station being
4
programmed.
The green light goes on.
Press [ ].
5
Enter
Press an available programmable button.
6
To save programmable buttons, assign Speed
NOTE:
Dial Access to virtual buttons (#01 through
#24 for 10-button sets; #01 through #12 for
22-button sets). If you program an available
button on a phone, mark it with an "X" to
indicate that it should not be used.
[ ] [ ] [ ] followed by any telephone number.
7
* 2 0
Press the button to confirm the selection.
8
Repeat steps 4 through 8 for each phone.
9
Press [
10
Conference
administration mode by sliding the T/P switch to the
center position.
] twice.
] to continue administration or leave
Required Settings
],
More
2-3