Installing The Merlin Mail System Unit; Environmental Considerations - AT&T MERLIN MAIL Implementation Manual

ENVIRONMENTAL
CONSIDERATIONS

Installing the MERLIN MAIL System Unit

1-4 Installing the MERLIN MAIL System
Place the MERLIN MAIL system unit on a sturdy flat
surface, such as a desk or table, or sidemount it with the
vent side up for proper ventilation. The location must
meet the following conditions:
Dry, dustfree area (relative humidity < 90%), no
potential exposure to water or liquids (avoid areas
around drinking fountains, coffeemakers, etc.).
Temperature range: 40 °F to 104 °F.
To install the MERLIN MAIL system unit, follow the
instructions below:
Using a Phillips® head screwdriver, loosen the four
1
screws located on the right and left sides of the
MERLIN MAIL system unit.
The MERLIN MAIL system unit must
WARNING:
be unplugged before removing the cover.
Hazardous voltage inside. Risk of electric shock.
Remove the cover.
2
Remove the two spacers that hold the voice processing
3
cards in place during shipment, then replace the cover.
Connect two or four line cords into the appropriate
4
ports.
Line cords must connect to ports 1 and 2 in
NOTE:
two port configurations.