Specifying Touch-Tone Or Rotary Signaling - AT&T MERLIN 3070 Administration Manual

SPECIFYING TOUCH-TONE OR ROTARY SIGNALING

When your system is installed, it is set to generate Touch-Tone signals. If some of
your lines are rotary, you need to reset your system accordingly. If you have rotary
lines or if you are not sure what type of lines you have, follow the procedure below.
If all your lines are Touch-Tone, turn to the next page to continue administering your
system.
To determine if your lines are Touch-Tone or rotary, go to the administrator/attendant
console and make sure that the T/P switch is in the center position. Then touch each
line button and dial out. If a line is Touch-Tone, you hear tones and the dial tone stops.
If a line is rotary, you hear tones but the dial tone is not interrupted. Follow the pro-
cedure below to specify Touch-Tone or rotary dialing.
1. If you have not already done so, enter the administration mode by following the
boxed instructions on page 28.
2. Touch Adm Misc.
The lights next to the administration mode buttons stop flashing, and the
green light next to the Adm Misc becomes steady.
3. Dial the 4-character code #302.
4. One by one, touch the line button for each line in your system until the green
light beside it shows the appropriate code. Each successive touch of a but-
ton gives you one of the following codes:
Steady green light on = Touch-Tone signaling
5. Touch Adm Misc again.
The lights next to the administration modes buttons flash.
6. Continue to administer your system or leave admistration mode by follow-
ing the boxed instructions on page 28.
Green light off = rotary signaling
29