Touch-Tone Enable; Account Number Entry (Only For Use With Smdr) - AT&T MERLIN 3070 Attendant's Manual

TOUCH-TONE ENABLE

To program: T/P to P Touch the button Dial
center
If your MERLIN system has lines that carry rotary signals, you can pro-
gram a button that allows you to switch to Touch-Tone signals to use ser-
vices such as an alternate long distance service or credit card
authorizations.
Lift your handset.
• Dial the first part of the number.
Y hear rotary clicks.
OU
Touch Touch-Tone Enable,
• Dial the remaining numbers.
You hear Touch-Tone signals.
You turn off the Touch-Tone Enable feature when you hang up your hand-
set or touch Recall.

ACCOUNT NUMBER ENTRY (Only for use with SMDR)

To program: T/P to
P
center
With this feature, you can associate an account number with any outside
calls you make or receive. The account number then appears on the
SMDR entry for that call, so your system administrator can keep track of
all calls going in and out of your MERLIN system.
To enter an account code:
Touch Account Number while you have a call in progress,
The green light next to the button flashes
Dial the account code on the dial pad.
Touch Account Number again.
The green light next to the button stops flashing.
If you
make a mistake as you enter an account code, simply repeat the
account code entry procedure while you're still on the call.
You
TIP: can program an account code onto a button the same way you
would program an Outside Auto Dial button. (See "Outside Auto Dial,"
page 37.)
50
*76
Touch the button Dial *82
T/P to
T/P to