Using Centralized Voice Terminal Programming 1 0 - AT&T MERLIN 3070 Administration Manual

USING CENTRALIZED VOICE TERMINAL PROGRAMMING
Using Centralized Voice Terminal Programming, you can assign features convenient-
ly to all voice terminals from the administrator/attendant console. You can use Cen-
tralized Voice Terminal Programming to assign any of the features described in this
section of the manual to individual voice terminals throughout your system.
1. If you have not already done so, enter administration mode by following
the boxed instructions on page 28.
2. Touch Conference.
The red light next to Adm Tel goes on.
3. Dial the intercom number or touch the Auto Intercom button of the voice
terminal you want to program.
The red light next to Adm Tel goes out and a single tone sounds every 5
seconds as a reminder that you are programming. This is similar to what you
would hear if you were programming the voice terminal itself.
terminal you are programming cannot be used to make ore receive calls during
this time, and callers get a busy signal.
If the voice terminal you want to program is busy, the red light next to Adm Tel
and the green light next to the Auto Intercom button of the voice terminal flash
alternately. You must wait for the voice terminal to become idle before
continuing to step 4. If you prefer not to wait, you can touch Conference again and
select another voice terminal to program, or touch Conference twice to terminate the
programming procedure.
4. Program any features you wish to assign to the voice terminal.
5. To program another voice terminal, repeat steps 2 through 4.
6. Touch Conference twice.
7. Continue to administer your system, or leave administration mode by following the
boxed instructions on page 28.
The voice
109