Specifying Touch-Tone Or Rotary Signaling - AT&T Merlin II Installation And Maintenance Manual

SPECIFYING TOUCH-
TONE OR ROTARY
SIGNALING
3 Press Adm Pool.
Green light comes on steady and two beeps sound.
4 Dial the pool code.
Press line buttons until your selection is shown:
5
Red light on = line in pool
Red light off = line not in pool
6 Press Adm Pool.
7 Press Conference to continue administration or leave
administration mode by sliding the T/P switch to the
center position.
Refer to Form la, System Form-Incoming Lines for
Release 3, or the System Configuration Form for Feature
Module 2 to determine if the system contains any rotary
lines. If it does, follow the appropriate procedure below:
With a Display Console
Enter administration mode by sliding the T/P switch to
1
P.
2 Press Conference twice.
The administration menu appears.
3
Press
[Lines], [More], [TchTone].
4 Press the line buttons until your selection is shown:
Green light on = Touch-Tone signaling
Green light off= rotary signaling
Lights next to tie line buttons do not light
NOTE:
when you perform this procedure.
5
Press Conference to return to the administration menu
or leave administration mode by sliding the T/P switch
to the center position.
Administering a New System 3-35