Feature Programming Chart 1 1 - AT&T MERLIN 3070 Administration Manual

Feature Programming Chart
Use the chart below as a quick reference when you want to program features onto your voice terminal.
Feature Name
(Suggested Button Label)
QUICK DIALING FEATURES
Outside Auto Dial
Name or
Location
Auto Intercom
Name or
Location
Manual Signaling
Signal Name
Personal Speed Dial
(uses a dial code in-
stead of a button)
System Speed Dial
Name of
Location
Saved Number Redial
Save Number
Last Number Redial
Last Number
Description
Dial outside telephone
numbers or PBX/Centrex
feature codes with one
touch.
Place ringing intercom
calls with one touch.
Generate a beep at
another person's voice
terminal.
Assign a 3-character code
(#01 through #22) to each
telephone number you call
frequently.
If you programmed
System Speed Dial codes
for frequently dialed
numbers, you can assign
any of them to buttons for
one-touch dialing.
Save a number indefinitely
for later redialing.
Redial the number you
dialed most recently.
Programming Code
• Dial 90.
• Dial an outside number,
an account number, or a
PBX,
Centrex, or
Custom Calling feature
code.
• Dial 91.
• Dial a MERLIN system
intercom number.
• Dial 6.
• Dial
the intercom
number for the person
you want to signal.
• Dial a Personal Speed
Dial code (#01 through
#22).
• Dial 90.
• Dial an outside tele-
phone number, a PBX,
Centrex, or Custom
Calling feature code, or
an account number.
• Dial 95.
• Dial a System Speed
Dial code (#60 through
#99).
• Dial 74.
• Dial 73.
Notes
A button with lights is recom-
mended but not required. The
green light goes on when the other
person is using his or her voice ter-
minal or is using the Do Not Disturb
feature. You can use an Auto inter-
com button whenever instructions
call for dialing an intercom number.
You cannot program both Auto in-
tercom and Manual Signaling for
the same voice terminal.
Use Manual Signaling to contact
someone with a prearranged
signal. If you program this feature
on a button with lights, the green
light goes on when the other person
is using his or her voice terminal or
is using the Do Not Disturb feature.
You cannot program Manual
Signaling and Auto Intercom for the
same voice terminal.
For 5-and 10-button voice terminals
only.
You assign System Speed Dial
codes to frequently called
numbers; then everyone connected
to your MERLIN system can use
those codes for abbreviated dialing,
It is not necessary to assign these
codes to buttons.
If you have a 5- or 10-button voice
terminal, you can dial a code to use
this feature instead of using a
button
If you have a 5- or 10-button voice
terminal, you can dial a code to use
this feature instead of using a
button.
117