Specifyng Touch-Tone Or Rotary Dialing - AT&T MERLIN 3070 Administration Manual

SPECIFYING TOUCH-TONE OR ROTARY DIALING
When your system is first installed, it is set for Touch-Tone dialing; so if some of your
lines are rotary you need to reset the system for rotary dialing. To determine if your
lines are Touch-Tone or rotary, go to the administrator/attendant console and make
sure the T/P switch is in the center position. Then touch each line button and dial
out. If a line is Touch-Tone, you hear tones and the dial tone stops. If a line is rotary,
you hear tones but the dial tone is not interrupted. Follow the procedure below to
specify Touch-Tone or rotary dialing.
1. If you have not already done so, enter administration mode by following the
boxed instructions on page 16.
2. Touch Adm Opt.
The green light beside Adm Tel goes out and the green light beside
Opt flashes slowly
Dial 3.
3.
The green light beside Adm Opt stops flashing and remains on.
4.
One by one, touch each line button until the green Iight beside it shows the
appropriate code. Each successive touch gives you one of these codes:
Steady green on = Touch-Tone signaling
5 Continue to administer your system, or if you have no further system ad-
. .
ministration to do, leave administration, mode by following the boxed instruc-
tions on page 16.
Green off = rotary signaling
Adm
19