AT&T MERLIN 3070 Administration Manual page 78

4. Dial the 2-character code #6
5. Dial the table number (0 through 7).
6. Dial the number (00 through 99) of the entry you want to record in the table
For 6-digit tables, Entry 00 is the area code and entries 01 through 99 are
exchanges within that area code.
7. Dial the area code of exchange you want to record.
8. If you want to remove an entry, repeat steps 4 through 6 and then touch Drop.
9. Repeat steps 4 through 7, or perform step 8, for each table entry you want
to administer.
If you need to administer the Pool, Absorb, and other Digits sections of your table, go on to
step 3 of the procedure that follows, which is headed "Administering Pool, Absorb, and
Other Digits Sections of ARS Tables." If not go on to step 10 below
10. If you have a printer connected to your system, you can get a printout of the complete set of ARS
tables. Sample printouts are shown on pages 56 through 57. To get a printout, dial
dial the 4-character code #902
The green light next to Adm Misc flashes. When the printout is completed, you hear a
beep and the green light next to Adm Misc becomes steady.
Don't go on to step 11 until you hear the beep or you will get an incomplete printout. Don't
remove the printout until you've completed step 11 or your page alignments will be affected.
11. Touch Adm Misc.
The lights next to the administration mode buttons flash again.
12. Continue to administer your system or leave administration mode by following the boxed
Instructions on page 28.
75