Resetting Smdr; Setting Your Printer To Scroll To The Top Of The Page - AT&T MERLIN 3070 Administration Manual

Resetting SMDR

MERLIN systems are factory-set to activate SMDR automatically as soon as you
enter the current time and date and any optional settings you need, then turn your
printer on. If this does not happen or if your call reports do not print out correctly,
you may need to perform the administration step shown below to activate or reac-
tivate SMDR.
1. If you have not already done so, enter administration mode by following
boxed instructions on page 28.
2. Touch Adm Misc.
The lights next to the administration mode buttons stop flashing, and the green
light next to Adm Misc becomes steady.
3. Dial the 5-character code #3160.
4. Touch Adm Misc.
The lights next to the administration mode buttons flash again.
5. Continue to administer your system, or leave administration mode by following
the boxed instructions on page 28.

Setting Your Printer to Scroll to the Top of the Page

Normally, your printer scrolls to the top of the next page and prints a new header when
it completes a report. If the heading is being printed in the middle of the page, reset
the printer by following the procedure below.
1. Turn off the printer and scroll the paper to the top of the next page.
2. Turn the printer on.
3. If you haven't already done so, enter administration mode by following the
boxed instructions on page 28.
4. Touch Adm Misc.
The lights next to the administration mode buttons stop flashing, and the green
light next to Adm Misc becomes steady.
5. Dial the 4-character code #399.
6. Touch Adm Misc.
The lights next to the administration mode buttons flash again.
7. Leave administration mode by following the boxed instructions on page 28.
101