Programming Simultaneous Voice And Data Calls 1 2 - AT&T MERLIN 3070 Administration Manual

126
PROGRAMMING SIMULTANEOUS VOICE AND DATA CALLS
When a voice terminal in your system is connected to a General Purpose Adapter
and a modem, it can link the user's computer terminal to a local or remote host com-
puter. With the Simultaneous Voice and Data Call feature, the user can place or
receive calls on his or her voice terminal without interrupting the exchange of data
between the computer terminal and the host computer. Use Centralized Voice Ter-
minal Programming or follow the procedure below to program this feature.
1. Go to the voice terminal you want to program.
2. Slide the T/P switch on the left side of the voice terminal to P.
The voice terminal rings every 5 seconds to remind you it is in program mode.
3. Touch Message until the green light next to it shows the appropriate code.
Each successive touch gives you one of these codes:
Steady green light on
Green light off = simultaneous voice and data calls not
4. If you have more features to program on this voice terminal, you can do so.
Otherwise, slide the T/P switch to the center position to return to normal
operation.
= simultaneous voice and calls permitted
permitted.