Quick Reference Guide To Administration Procedures - AT&T MERLIN 3070 Administration Manual

Quick Reference Guide to Administration Procedures

This chart summarizes the administrative procedures described on pages 29 through 126. For more information about
a procedure, refer to the page listed.
Before you perform any of these procedures, enter administration mode by following the steps below.
• Set switch A on the Processor Module in the control unit to Administer (down).
• Insert the administration mode button labels (seethe back of this manual) in the administrator/attendant console.
• Slide the T/P switch on the left side of the console to P.
When you finish administering your system, leave administration mode by following the steps below.
• Slide the T/P switch to the center position.
• Set switch A on the Processor Module to Attendant (up).
• Remove the administration mode button labels from the console and insert the regular call-handling labels used
by the attendant.
NOTE: If you have an economy administrator/attendant console, perform this procedure instead of touching an
Auto Intercom button:
• Dial the intercom number to identify a voice terminal.
• Touch Hold and dial the intercom number to add a voice terminal to a group or list.
• Touch Drop and dial the intercom number to remove a voice terminal from a group or list.
• Touch Drop and then touch * to remove all the voice terminals from a group or list.
Procedure
PERFORM BASIC ADMINISTRATION
Specify Touch-Tone or rotary
signaling.
(See page 29.)
Set system to work with Call
Management System (CMS)
or
Set system to work without
CMS (default)
(See page 30.)
Assign lines to voice ter-
minals in square systems.
(See page 31.)
Set up line pools in pooled
systems.
(See page 35.)
Touch
Adm Misc • Dial #302.
• Touch line buttons.
Steady green on = Touch-Tone
Green off = rotary
• Touch Adm Misc.
• Dial #3141.
Adm Misc
• Touch Adm Misc.
• Dial #3140.
Adm Misc
• Touch Adm Misc.
• Touch Auto Intercom button representing voice terminal.
Adm Tel
• Touch line buttons.
Steady green on = line is assigned
Green off = line is not assigned
• Touch Adm Tel.
Adm Pool • Dial pool code (9 for main pool or 890 through 899 for additional
pools) if administering more than one line pool.
• Touch line buttons.
Steady red on
Red off = line is not in pool
• Touch Adm Pool.
Then
= line is in pool
183